OpenThread demo board not recognized

Golioth Device Help
#1

Hi Team
I had followed the steps provided in Create a node on your Thread Network | Golioth Thread Demo to build and flash the end device.
West flash gives me a warning also, I’m not sure about the amount of data written

image
image1249×139 30.5 KB

After this, when I try to open the serial port to configure networkkey and networkname, the unit becomes unresponsive after 10-15 seconds

image
image666×790 51.6 KB

#2

Hello! Two initial questions:

  • Can you share the full compilation output? Wondering what if there may be other hints in the output.
  • Can you try flashing a test app to see if those hang too?
#3

Actually, could it be the same issue as discussed here? Connect Thread Node to Golioth - #2 by ChrisGammell

#4

Hi Jonathanberi
Yes, I actually used the link provided in the above thread to install the requirements and I have seen the expected build. Even the flash happened and successfully connected once to a thread border router. The next day I was not able to connect and I see the serial output becomes unresponsive after 10-20 seconds.
Here are the compilation attachments (I build this today)

Screenshot from 2022-11-24 11-12-33
Screenshot from 2022-11-24 11-12-331862×1054 169 KB

Also for flash
Screenshot from 2022-11-24 11-13-09
Screenshot from 2022-11-24 11-13-091862×1054 178 KB

#5

Hi Team, I’m able to connect BT510 sensor consistently with TBR. The updated repo helped me
No freezing reported.
Thanks all for the support

#6

Awesome news! Can’t wait to hear more about the BR solution!

If other people find this post in the future, the repo was updated in this PR: v0.5.0 API update by ChrisGammell · Pull Request #6 · golioth/golioth-openthread-demo · GitHub